Studi Kejenuhan pada Current Transformer (CT) Akibat Arus Hubung Singkat
DOI:
https://doi.org/10.55893/jt.vol22no1.535Keywords:
current transformer, Mathcad, saturate, ATPDrawAbstract
The CT saturation analysis approach model was carried out using ATPDraw and Mathcad software simulations. Input simulation data obtained from CT testing at West Priok Substation, namely ratio, excitation curve V-rms-Irms, Rct. Based on the simulation results, the CT model was successfully implemented for CT conditions at the West Priok Substation which experienced saturation, as seen from the results of the distorted waveforms and the THDi value of 40.612%. These results are then compared with the IEC 61869-2 standard with the parameters obtained from the CT-Analyzer test on E-t, Ek, Ie, Kx, and Rct, that E-t is -1%, Ek is 635.25 V, Ie is 13.5 mA, Kx of 0.084 and Rct of 7432.57 ohm. This result is a deviation from the specified standard, meaning that the CT is damaged and saturated. After replacing the CT, it was tested again and the value of E-t was -0.010%, Ek was 936.09 V, Ie was 9.68 mA, Kx was 14.39 A, Rct was 4.226 ohm, and the waveform simulation results were not distorted, then the THDi value obtained by 0.08%. This indicates that the CT is in good condition and does not experience saturation when the short circuit current is 20 kA.
Downloads
References
Afonso, J. I., Toscano, P., & Briozzo, I. (2020a). Current Transformer model validation on EMTP-ATP software. 2020 IEEE PES Transmission and Distribution Conference and Exhibition - Latin America, T and D LA 2020. https://doi.org/10.1109/TDLA47668.2020.9326157
Afonso, J. I., Toscano, P., & Briozzo, I. (2020b). Current transformer modeling for electromagnetic transient simulation in protection systems. 2020 IEEE PES Transmission and Distribution Conference and Exhibition - Latin America, T and D LA 2020. https://doi.org/10.1109/TDLA47668.2020.9326170
Ahamed, R. M., & Rao, A. S. (2015). Saturation Analysis of Current Transformer. International Journal of Research & Review (Www.Gkpublikation.In), 2(6), 337.
Biswal, S., & Biswal, M. (2019). Detection of current transformer saturation phenomenon for secured operation of smart power network. Electric Power Systems Research, 175(October 2018), 105926. https://doi.org/10.1016/j.epsr.2019.105926
BPPT. (2019). Outlook Energi Indonesia 2019 The Impact of Increased Utilization of New and Renewable energy on the National Economy. https://doi.org/10.1017/CBO9781107415324.004
Education, M. (2021). Modelling of Power Transformer for Differential Protection Using ATP-EMTP. 12(9), 2770–2776.
Georgiev, D., Rangelov, Y., & Georgiev, G. (2021). Current Transformer Performance under High Voltage Cable Related Transients. 2021 13th Electrical Engineering Faculty Conference, BulEF 2021, September. https://doi.org/10.1109/BulEF53491.2021.9690825
Hasanah, A. W., Koerniawan, T., & Yuliansyah, Y. (2019). Kajian Ketelitian Current Transformer (CT) Terhadap Kesalahan Rasio Arus pada Pelanggan 197 kVA. Energi & Kelistrikan, 11(1), 9–16. https://doi.org/10.33322/energi.v11i1.390
Herlender, J., Izykowski, J., & Solak, K. (2020). Compensation of the current transformer saturation effects for transmission line fault location with impedance-differential relay. Electric Power Systems Research, 182(January). https://doi.org/10.1016/j.epsr.2020.106223
IEC 61869-2. (2012). International Standard International Standard. In 61010-1 © Iec:2001 (Vol. 2003).
Ilyas, I., & Agassy, M. T. (2021). ANALISIS KEGAGALAN CURRENT TRANSFORMER ( CT ) TIPE DUA BELITAN SEKUNDER DENGAN INTI MAGNETIK TERPISAH PADA SISTEM PROTEKSI DAN PEMBATAS DAYA Iriandi Ilyas dan Muhamad Taufan Agassy Program Studi Teknik Elektro FTI-ISTN Jl . Moh . Kahfi II Jagakarsa , Jaka. Sinusoida, XXIII(1), 1–10.
Kanokbannakorn, W., & Penthong, T. (2019). Improvement of a Current Transformer Model based on the Jiles-Atherton Theory. 2019 IEEE PES GTD Grand International Conference and Exposition Asia, GTD Asia 2019, 3, 495–499. https://doi.org/10.1109/GTDAsia.2019.8715956
Marwan, M., L, R., & Samsul, N. M. (2016). Analisis Gangguan Tidak Seimbang pada Line Transmisi GI Sungguminasa-GI Tallasa. INTEK: Jurnal Penelitian, 3(2), 102. https://doi.org/10.31963/intek.v3i2.60
Naseri, F., Kazemi, Z., Farjah, E., & Ghanbari, T. (2019). Fast Detection and Compensation of Current Transformer Saturation Using Extended Kalman Filter. IEEE Transactions on Power Delivery, 34(3), 1087–1097. https://doi.org/10.1109/TPWRD.2019.2895802
Seo, H. C., & Gwon, G. H. (2019). Systematization of the simulation process of transformer inrush current using EMTP. Applied Sciences (Switzerland), 9(12), 1–16. https://doi.org/10.3390/app9122398
Setia, G. A., Sianipar, G. H. M., & Paribo, R. T. (2016). The performance comparison between fast decoupled and backward-forward sweep in solving distribution systems. 3rd IEEE Conference on Power Engineering and Renewable Energy, ICPERE 2016, 247–251. https://doi.org/10.1109/ICPERE.2016.7904871
Syahputra, R. (2015). Uji Karakteristik Transformator Arus Berbasis Perangkat Lunak EMTP (Characteristic Test of Current Transformer Based EMTP Software). JTE-U, 1(1), 1–5.
Transformers—Part, I. (1996). 1: Current Transformers. IEC Std, 60, 41–44.
Wen, J., Chen, W., Jiao, X., Wu, M., & Zheng, T. (2021). Integration of a Protection/Measurement Current Transformer based on Compensation Algorithm. 2021 IEEE 4th Student Conference on Electric Machines and Systems (SCEMS), 1–6. https://doi.org/10.1109/SCEMS52239.2021.9646084
Zhao, J., Chen, W., Li, K., Teng, Z., Li, N., Wen, T., & Fan, X. (2023). Analysis of Conducted Disturbance via Current Transformer Due to Switch Operation of GIS Disconnector in UHV Substation. CSEE Journal of Power and Energy Systems, 9(3), 1227–1234. https://doi.org/10.17775/CSEEJPES.2021.05580
Additional Files
Published
How to Cite
Issue
Section
License
Copyright (c) 2023 Giri Angga Setia, Een Taryana, Naufal Nur Aiman, Ahmad Daelami, Hikmah Prasetia
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Penulis yang menyerahkan artikel di Jurnal Teknik: Media Pengembangan dan Aplikasi Teknik untuk keperluan publikasi telah mengetahui bahwa Jurnal Teknik: Media Pengembangan dan Aplikasi Teknik memberikan akses terbuka terhadap konten untuk mendukung pertukaran informasi mengenai ilmu pengetahuan, sesuai dengan penerbitan daring yang berbasis Open Access Journal dan mengikuti Creative Commons Attribution 4.0 International License. Sehingga penulis setuju dengan ketentuan-ketentuan berikut:
1. Penulis memegang hak cipta dan memberikan hak publikasi pertama kepada pihak jurnal dengan pekerjaan secara bersamaan
di bawah Creative Commons Attribution 4.0 International License yang memungkinkan orang lain untuk berbagi pekerjaan
dengan pengakuan kepengarangan karya dan publikasi pertama artikel tersebut di Jurnal Teknik: Media Pengembangan dan
Aplikasi Teknik.
2. Penulis dapat melakukan perjanjian tambahan untuk hak distribusi non-eksklusif artikel yang telah diterbitkan di jurnal ini
(misalnya, posting ke sebuah repositori institusi atau menerbitkannya dalam sebuah buku), dengan mengakui bahwa
publikasi pertama dilakukan di Jurnal Teknik: Media Pengembangan dan Aplikasi Teknik.
3. Penulis diizinkan dan didorong untuk menyebarkan karya mereka secara daring (misalnya, dalam repositori institusi atau
laman web penulis) setelah artikel terbit (proses penerbitan artikel selesai). Hal ini terkait dengan imbas dari pertukaran
informasi yang produktif (Lihat Pengaruh Open Access).
